Page 1: Blank
- Figure 1 - Blank Interface
Purpose: This interface provides various methods of blanking (i.e., hiding or masking) selected entities. Unlike SelPar, which allows entire parts to be turned on/off, Blank operates primarily at the element level. This interface is available for both pre and post-processing phases. Entities are selected using the General Selection Interface.
Controls:
Node - Blank nodes
Element - Blank elements- CNRB - Blank *CONSTRAINED_NODAL_RIGID_BODYs
- Curve - Blank curves
- Surface - Blank surfaces
- Particle - Blank particles
- Shell - Select shell element
- Solid - Select solid element
- Beam - Select beam element
- Tshel - Select tshell element
- SPH - Select SPH element
- Mass - Select mass element
- Disc. - Select discrete element
- Seat. - Select seatbelt element
- Iner. - Select inertia element
- AnyE - Select any element
Blank the selected elements
UnBlank Part - Unblank picked part
Auto-Apply - Automatically perform Apply after selection- Auto-Update - Automatically update solid outer surfaces and edges after blanking
Blank all visible elements
Unblank all elements
Reverse blanked/un-blanked elements
Update the 3D outer surface
Update edge line
UnBlank last blanked elements
Exit Element Blanking interface
