Page 2: Renum (Renumber)
- Figure 1 - Renum Interface
Purpose: This interface can be used for renumbering and offsetting of entities within a model. This is only available during the pre-processing phase. An entire model can be renumbered or individual data types like nodes, materials, etc... can be renumbered and offset. For each entity type, either all or a specified range can be renumbered/offset. Upon renumbering or offsetting all referenced data will get updated by LS-PrePost.
Side Panel
Renumbering - Renumber keyword file by user ID
Offset - Renumber keyword file by offset user ID
Bottom Panel
- All - Renumber/Offset all
- Range - Renumber/Offset range ID
- From: Input first ID
- To: Input last ID
- Start ID: Renumber start ID/offset value
Renumber or offset current data
Clear current selection
- Figure 2 - Renum Bottom Panel
Popup Window
- Default Renumber StartID: Renumber started/offset value
Renumber keyword tile
Cancel renumber keyword file
Edit more keyword shift value
Renumber keyword file by user ID
Cancel renumber keyword file
- Figure 3 - Renum Popup
