logo
Online Documentation
LSTC
lspp
chat

Page 5: LoadPt

  • loadpt panel
  • Figure 1 - LoadPt Interface

Purpose: This interface allows the user to interactively show, create, modify, and delete loads. It is an alternative to creating loads using Page 3 keyword cards in that load points can be directly picked from the graphics viewport. The following keywords are supported:

  • *LOAD_NODE_POINT
  • *LOAD_NODE_SET
  • *LOAD_RIGID_BODY

Controls:

  • rbs Show - Show existing load point entities
  • rb Modify - Modify existing load point entities
  • rb Create - Create new load point entities
  • rb Delete - Delete existing load point entities

For Show, Modify, and Delete, the Entity Operation Interface is displayed in the secondary controls area. For Create, the General Selection Interface is displayed in the secondary controls area.

  • rbs Plane - Set current section type for plane
  • rb Set - Set current section type for set
  • rb Rigid - Set current section type for rigid

  • Label: Set current entity label type

  • DOF: Set current DOF type

  • LCID: Load Curve ID
  • CID: Coordinate System ID

  • cbc N1: Node ID 1
  • cb N2: Node ID 2
  • cb N3: Node ID 3
  • cb ID: Node, Part, Node Set ID (Modify Only)

All
 Select all LoadPoint
None
 Deselect all LoadPoint
Rev
 Reverse selection LoadPoint
Alist
 Select all entities within the selected range
Apply
 Apply entries for creation/modification
Cancel
 Cancel this modification or selection
Write
 Write selected load data to file
Done
 Exit LoadPoint data interface

  • Click item from list to select (1)

page end
© 2012 Livermore Software Technology Corporation