logo
Online Documentation
LSTC
lspp
chat
p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 p13 p14 p15 p16 p17 p18 p19 p20

Tutorial 4: Page 19

  • 19. Mesh middle and right areas
  • click the Mesh Icon

  • click the edges and accept the meshes for the center and right areas when prompted (see Figure 19)
  • note: the selection of edges will propagate by default but will stop when there is more than one edge connected to an edge end point

  • fig19
  • Figure 19

page end
© 2012 Livermore Software Technology Corporation