logo
Online Documentation
LSTC
lspp
chat
p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 p13 p14 p15 p16 p17 p18 p19 p20

Tutorial 4: Page 20

  • 20. Exit the 2Dmesh Sketchboard
  • click Exit (the entities will remain on the Sketchboard if it is activated again during the same LS-PrePost session)

  • click Acen in the main window
  • click Mesh in the main window (see Figure 20)
  • note: the nodes on the three mesh areas can be merged using the DupNod Interface

  • fig20
  • Figure 20

page end
© 2012 Livermore Software Technology Corporation