logo
Online Documentation
LSTC
lspp
chat
p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 p13 p14 p15 p16 p17

Tutorial 5: Page 10

  • fig14
  • Figure 14
  • 10. Automatically position parts
  • go to page 2: PTravel (see Figure 14)

  • pick the blank in the graphics window (cyan)
  • activate cbc Fixed Parts
  • click Right render button
  • pick the punch in the graphics window (green)
  • set cbc T1 cb T2
  • enter Gap=0.1
  • click Z
  • click Flip Dir. (should now be Z=-1)
  • click AutoPos
  • click Accept (see Figure 15)

  • activate cbc Moving Parts
  • pick the die (red)
  • activate cbc Fixed Parts
  • click Top render button
  • pick the blank
  • set cb T1 cbc T2
  • click AutoPos
  • record distance (-40.100839) to be used as the stroke for the die travel
  • click Accept

  • activate cbc Moving Parts
  • click Bottom render button
  • pick the binder (yellow)
  • activate cbc Fixed Parts
  • click Right render button
  • click +10 render button (changes to -10)
  • click Rx render button
  • pick the blank
  • click Flip Dir. (should now be Z=1)
  • click AutoPos
  • click Accept (see Figure 16)

  • fig15
  • Figure 15
  • fig16
  • Figure 16

page end
© 2012 Livermore Software Technology Corporation